Buy the replica IW371698 only from a maker that reproduces the 41 mm Portugieser case, a case height close to 13 mm, and the two-register chronograph layout with elapsed minutes at 12 and running seconds at 6. If the listing shows a 40 mm case, subdials at 3 and 9, or a date window at 3, that is a different watch wearing the reference number, and it will look wrong on the wrist at arm's length. The second filter is the pusher feel and the reset snap, which tell you more about the movement inside than any photograph of the movement plate.
Our pick, then the alternatives
Start with the top-tier build that clones the 69355 architecture: column wheel, vertical clutch, no date, correct subdial spacing, and a boxed sapphire crystal with coating on both faces. That version keeps the slim profile and the crisp pusher action that define the watch. Only drop to a mid-tier build if the budget is tight and you accept a thicker caseback. Skip the entry tier entirely if the dial is the part you care about, because that is where the shortcuts show first.
What separates a good replica IW371698 from a weak one
- Dial printing and applied markers. The numerals should be applied metal with polished edges, not printed flats. The minute track is a fine railway scale that meets the subdials with clean gaps.
- Subdial geometry. Centers sit on a vertical line through the hand stack. Any sideways drift is visible in every photo.
- Bezel and lugs. A narrow, polished bezel and long tapered lugs. Over-polished lugs round off the case edge and read as costume jewelry.
- Caseback engraving. Sellers who hide the caseback in the gallery are hiding the engraving depth and the rotor finish.
- Hands. Leaf-shaped, faceted, with a slight dome. Flat stamped hands are the giveaway on cheap builds.
Parameter bands to check before you pay
- Case diameter: 40.9 mm to 41.1 mm, measured without the crown.
- Case height: 12.8 mm to 13.3 mm on the top tier, up to 14.5 mm on 7750-based builds.
- Lug width: 20 mm, so straps from the original fit.
- Movement: column wheel chronograph, about 28,800 vph, power reserve near 46 hours.
- Crystal: boxed sapphire, front and display back, anti-reflective coating on at least the inner face.
- Weight on leather: roughly 75 g to 85 g. A heavy case means a thick midcase.
- Water resistance: treat the claimed 30 m as splash resistance only, and never swim in it.
Where buyers get burned
- Stock photographs from the brand's own press set, followed by a different watch on delivery.
- A date aperture at 3 that the reference never had.
- Chronograph seconds that stutter instead of sweeping, a sign of a cheap quartz conversion.
- Reset that lands at 2 seconds past zero and never returns.
- Seller claims of titanium or platinum on a steel-priced listing.
FAQ
Does the replica use a real column wheel?
On the top tier, yes, and the pusher feel confirms it: light, short travel, no grit. On cheap builds a cam module copies the look without the mechanism.
Replica IW371698 Alternative: Best IWC Portugieser Picks
Is a 7750-based version worth considering?
It runs and resets fine, but the rotor and the thicker midcase push the height past 14 mm and change how the watch sits under a cuff.
How do I verify subdial spacing from photos?
Ask for a straight-on shot with the crown at 3, then draw a line through both subdial centers. It should pass through the hand stack on a 90 degree axis.
Can I service one locally?
A competent watchmaker can regulate and clean a cloned chronograph movement, but parts availability is the real limit. Ask before you buy.